VAT-UP200S-4.5-55L

OUTPUT

DC Output

4.5V

Rated Current

40A   ( PSU bottom fixed on heat sink of square > 250*250*3mm aluminum plate)

Current Range     Note 1

0~40A

Ripple and Noise

25~65℃

≤150mV

0~25C

≤200mV

Voltage Adj. Range

2.8~5.10V

Voltage Accuracy

±2.0%

Line Regulation

±0.5%

Load Regulation

±2.0%

Set-up Time

≤2S (230Vac input, Full load)

Hold up Time

≥10mS(220Vac input , 80% load)

Temperature Coefficient

±0.03%/℃

Overshoot

<5%

INPUT

Voltage Range

90Vac~264Vac

Frequency Range

47Hz~63Hz

Efficiency ( Typical)

89%(230Vac input ,full load)

AC Current (max.)

<3A

Inrush Current (Typical)

<80A@220Vac      Cold start

Power factor

PF>0.98/120VAC    &    PF>0.95/230VAC   (at full load)

PROTECTION

Over Power

202.5W~270W, Hiccup, auto recovery

Over Voltage

5.2~6V, constant voltage, auto recovery

Over Current

45A~60A, Hiccup, auto recovery

Shorted Circuit

Long-term mode, auto recovery

ENVIRONMENT

Operating amb. Temp. & Hum.

-40℃~65℃;  20%~90%RH  No condensing   (refer to the derating curve)

Storage Temp. & Hum.

-40℃~85℃;  10%~95%RH  No condensing

SAFETY &EMC

Note 3

Safety Standards

UL60950-1 2nd Ed; IEC 60950-1:2005(2nd Ed) ;EN60950-1:2006

Withstand Voltage

Primary-Secondary: 3.0KVac/10mA .Primary-PG:1.5KVac/10mA. Secondary-PG: 0.5KVDC/10mA.

Leakage Current

Input—output: ≤0.25mA     Input—PG: ≤3.5mA  （264Vac input, 63Hz）

Isolation Resistance

10M ohms

EMI Conduction

Compliance to EN55022, EN55024, FCC PART 15   CLASS A

EMI Radiation

Compliance to EN55022, EN55024, FCC PART 15   CLASS B

Harmonic Current

Compliance to EN61000-3-2  CLASS D

EMS Immunity

Compliance to EN61000-4-2,3,4,5,6,8,11;

OTHERS

MTBF (MIL-HDBK-217F)

More than 200,000Hrs (25C, full load)

Dimension  (L*W*H)

165*55*26.5mm

Packing

16pcs/CTN

Cooling method

PSU bottom fixed on heat sink of square > 250*250*3mm aluminum plate or forced air convection

NOTE

1.     All parameters NOT specially mentioned are measured at rated input, rated load and25℃ of ambient temperature.

2.     Measured at 20MHz of bandwidth by using a12”twisted pair-wire terminated with a 0.1 uF & 100uF parallel capacitor.

3.  The SPS is considered a component which will be installed into final equipment. We cannot guarantee that the final equipment will meet EMC directives, Final product manufactures must be re-confirm that their product meets EMC directives.